Trigger

 Trigger -- Routes events around with delay and/or counting.

(Alen Ladavac)

(Advice from Alen Ladavac on setting up a touchfield to trigger something repeatedly, at a given time delay:

Touchfield has one target for entering and one for leaving.  Make sure you set up  the exit-check time (frequency for rechecking for exit).  Then make a loop of two  triggers, one has a delay of one second.  On enter, activate and trigger one of  them, on exit, deactivate it.  Maxtrigs must be set to ? to allow repetition.  Also,  there must be a delay ("Wait") on at least one of them.)

(Kallisti)

Trigger

Count Use - if checked, then the trigger must be

targeted "Count" of times before the trigger is fired

Count - number of times required before trigger fires

Count Reuse - if checked, count returns to Count and

it can be triggered again, otherwise triggers only

once

Count Tell - if checked, prints "X to go" messages

Wait - Once trigger is set to fire, waits this number

of seconds before firing

Message - displays this message on the screen when the

trigger is activated

Score - adds to score when trigger is hit, counts as a

secret